Norton Footrest Rubber - Holding Brackets - Normal Roadgoing Type (4 pieces)

These laser cut brackets can be brazed or pressed onto a tube that feeds over the Norton footrest bar if your original brackets are bent or damaged, as so many often are. They are designed to hold the distinctive kidney shaped Norton rubbers.  come as a set of 4 brackets

These lasercut kidney shaped footrest rubber brackets are of exactly the same profile as original Norton items and can be used to replace your original items if they are damaged or missing.  Originally they were fitted over a tube, and the tube punched out into the recess on each side of the central hole on the bracket, to hold them in place.  The tube with brackets attached were then fitted over the length of bar that was screwed into the Norton footrest hanger on all roadgoing models.

It is worth noting that if you are missing the entire footrest rubber assembly - we also sell that as a complete unit (pair) - see Item 0211 in the same Fabrication section.  However these plates are useful if you wish to repair an original item, or make up your own set.

This type were fitted to most roadgoing models - i.e. Side Valve, OHV and SOHC . . . but we also sell similar footrest rubber brackets with an outer lip - which were as used on some competition International models - to stop your foot slipping off - Item 0209B, or the distinctive pre-war Manx type, with a much larger upright flap Item 0210 - which were normally brazed to the pre-war type rear frame fitting footrests