2 part throttle cable adjuster and locknut to fit original Amal TT and RN competition carburetters (with 3/8" diameter BSC thread), CNC manufactured in stainless steel, but with the same profile and distinctive knurl as the original competition item.
Price is per Adjuster and Locknut
These are CNC manufactured from stainless steel with the distinctive flat top face above the knurl - only fitted to the earlier Amal TT and RN type racing carburettors (up until the early 1950's - later competition carbs being fitted with the more common monoblock road type). Locknut uses the correct imperial across flats dimension as the original (originals being used as the template for these).
This cable adjuster was fitted mainly to the earlier (pre mid 50's at a guess) original Ama TT and RN carb tops. Originally they were were manufactured in brass and dull nickel plated, and were fitted with 3/8" diameter BSC fine thread cable adjuster. An original adjuster and locknut is shown in the second photograph alongside our version, and was used as a template. However, because they were made in brass - they were often 'mauled' with pliers and it is now very rare to find this original and distinctive design still in good condition.
It should also be noted that this original type of threaded adjuster was also counterbored underneath to fit the early type straight throttle spring, as shown in the second photograph. Our versions have the same counterbore. We also sell both the parrallel type spring and the later conical type spring . . . bot types can be used with this adjuster if required.
The original adjuster was in brass and very often seized in the carb top . .. and then owners tried to remove them - invariably with a pair of pliers - so it is normal to find carbs missing these adjusters, or at least with the knurl chewed or crushed. Our versions are CNC manufactured in stainless steel, so as well as looking nice, will be stronger than the brass originals.
Final point - later alloy top caps (probably mid 1950's onwards) were often fitted with smaller inner diameter alloy caps - and sometimes smaller adjusters, or no thread in them at all. For this later type of cap - see the later adjuster we also offer - Item 0145, later in this section.
We CNC manufacture these in stainless steel to the original design so they do not rust and will add the final touch to your competition carb restoration - but although small they still require multiple machining ops (including the slim nut which requires a special 2nd op to remove scurf after parting), hence the price.