7/16" Plain Washer (Standard Width) - Stainless Steel: Pack of 10

7/16" Plain Washer (Normal width) in stainless steel.  Useful for larger bolt application on British Motorcycles.  Sold as bag of 10.

These 7/16" washers are useful for many of the larger bolts used on Norton chassis, and are a width useful if wanting to spread load - like fork areas etc.  

Outer Diameter of these washers is nominal 22.0mm (but may vary fractionally by batch)

Note - we also supply 7/16" 'reduced head' washers (Item 0661) which have a reduced outer diameter - specifically for a number of Norton single engine bolts - where it was normal practice for Norton to use 7/16" engine bolts with a narrower, deeper, hex head than would be normally used.  However, we often go out of stock of that type (as they are difficult to get made), in which case - these can be used and should not overhang engine plates, although I find the 0661 look more correct for that application. 

I tend to use these for all other 7/16" bolt application though and are good quality UK sourced like all our stainless washers.