1 BA x 7/8" CNC bar turned Stainless Steel Cheesehead Screws - per pair. Most common size for handlebar fittings and other smaller fittings such as electrical.
These cheesehead screws are CNC machined by ourselves in-house, and have the correct curved cheesehead as was seen fitted to many levers and controls on British bikes. They are stainless steel and if we say so ourselves are very nice quality - not the normal mass produced screws.
They add the finishing touch to your latest restoration, or just spruce up your unrestored bike - as it is very common to see the screws on older bikes chewed and the screwdriver slot unusable (see the 4th photograph in this listing - an original rusty screw replaced by one of our nice new ones, that wont rust!). The slots on these screws are just the right depth and allow a bit more purchase than cheap modern 1BA screws.
Please Note: I have seen British bike levers/controls fitted with different screw threads sizes over the years - most commonly 1BA (e.g. our competition levers are fitted with 1 BA screws) and we sell both. I think 2BA screws are more commonly found on electrical switch's. This listing is for 1BA screws, where the outside diameter of the thread is 0.209"/5.30mm. If you do not have an original screw for your controls and are not sure which to order - then a 1BA thread will allow a No18/0.168"/4.28mm drill to just pass through it
FYI - if you wish to fit these with a suitable washer, we also sell 3/16" stainless spring washers, which are a perfect fit for these screws - Item 0100