Stainless Steel rear brake pedal pivot bolt and nut to fit SOHC International models (Model 30 and Model 40) for Rigid and Gardengate framed models. This is the pivot bolt that screws into the frame from which the rear brake pedal pivots. If your brake pedal currently flops about, there is a good chance it is this pin that is worn
It is worth noting that there have been quite a few variations on this brake pivot bolt over the years, but this is type that was most commonly fitted to SOHC road going models.
It is distinguishable by two features:
- The thread that screws into the frame is 7/16" x 20 tpi BSC (not 1/2" BSC as on OHV/SV models)
- The length of the shaft is 1.00" (one inch), which should be the width of hole on your brake pedal. If your brake pedal is shorter (i.e. 0.885") then instead see item 0654 as that is a Manx type brake pedal.
These brake pedals are CNC machined in-house and if I say so myself are quite nice! As well as not rusting, the stainless Hex will also improve the look in this area.
They also come fitted with one of our special wide pan washers (dull nickel plated) which properly retains the brake pedal. finally it also comes with stainless steel retaining nut. At time of this listing being written (April 2017) we are supplying the pin with a 5/16" BSC Nyloc Nut, but as I am unable to obtain these any longer, once current stocks are gone we will supply with an in-house made extra depth stainless 5/16" Nut
If you have a SOHC International model with a different Brake Pivot bolt to this, then see also items 0652 and 0654 as I gather sometimes other types were fitted. If you think you have a different variation, then please email at firstname.lastname@example.org as we may be able to offer those by special order. Final note, these may also fit Featherbed International models, but please check dimensions above